News > PROTECTIVE-Release: more than 40 carbon pieces without re-applying the release agent!
PROTECTIVE-Release: more than 40 carbon pieces without re-applying the release agent!
NO release failure.
NO poor release, and particles from moulding material remain on the mould.
NO poor release and white patches on parts.
NO Build-up or release agent on the mould or transfer of release to the moulded part.
PROTECTIVE-Release creates an ultra-thin layer on the mold surface, capable to reduce the adhesion of composites during the molding phase. It has a permanent action, increasing the life of the mold, without degrading and releasing the classic white residues on the molded part.
PROTECTIVE-release is also good for carbon fiber mold.
.jpg)
.jpg){kind=link}
Before applying PROTECTIVE-Release: remove residues of composites and release agent from the mold, then clean the surface with heptane.
Once the surface is clean, apply PROTECTIVE-Release by hand, with a short-bristled microfibre cloth, or by spray with an airbrush, taking care not to leave uncovered areas.
After application of PROTECTIVE-Release, put the mold inside the oven at a temperature of 90-100°C for 1 hour.
Complete cross-linking occurs a few days after application.